MSI PM9M-V Datenblatt PDF herunterladen (Seite 11)

are matched.

7. Visually inspect if the CPU is seated well into the socket. If

not, take out the CPU with pure vertical motion and reinstall.

8. Cover the load plate onto the package.

9. Press down the load lever lightly onto the load plate, and

then secure the lever with the hook under retention tab.

10. Align the holes on the mainboard with the cooler. Push down

the cooler until its four clips get wedged into the holes of the

mainboard.

11. Press the four hooks down to fasten the cooler. Then rotate

the locking switch (refer to the correct direction marked on it)

to lock the hooks.

12. Turn over the mainboard to confirm that the clip-ends are

correctly inserted.

Important:

Read the CPU status in BIOS.

Whenever CPU is not installed, always protect your CPU socket pin with the plastic cap

covered to avoid damaging.

Mainboard photos shown in this section are for demonstration of the CPU/cooler installation

only. The appearance of your mainboard may vary depending on the model you purchase.

Installing Memory Modules

1. The memory module has only one notch on the center and will only fit in the right

orientation.

2. Insert the memory module vertically into the DIMM slot. Then push it in until the

golden finger on the memory module is deeply inserted in the DIMM slot. You can

barely see the golden finger if the memory module is properly inserted in the DIMM

slot.

3. The plastic clip at each side of the DIMM slot will automatically close.

Volt

Notch

Important:

DDR2 memory modules are not interchangeable with DDR and the DDR2 standard is not

backwards compatible. You should always install DDR2 memory modules in the DDR2

DIMM slots.

Under Vista Series OS, memory module of 1GB (or above) is highly recommended

PDF created with pdfFactory Pro trial version www.pdffactory.com

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 90 91

Keine Kommentare

MSI PM9M-V Datenblatt Seite 11