MSI MS-8801 Spezifikationen PDF herunterladen (Seite 39)

3-7

BIOS Setup

If your hard disk drive type is not matched or listed, you can use Manual to

define your own drive type manually.

If you select Manual, related information is asked to be entered to the following

items. Enter the information directly from the keyboard. This information

should be provided in the documentation from your hard disk vendor or the

system manufacturer.

Access Mode The settings are CHS, LBA, Large, Auto.

Capacity The formatted size of the storage device.

Cylinder Number of cylinders.

Head Number of heads.

Precomp Write precompensation.

Landing Zone Cylinder location of the landing zone.

Sector Number of sectors.

Floppy Drive A:/B:

This item allows you to set the type of floppy drives installed. Available

options: Not Installed, 1.2 MB 5¼, 720 KB 3½, 1.44 MB 3½ and 2.88 MB 3½.

Floppy 3 Mode Support

This item allows you to set the Floppy 3 Mode. Available options: Both, .

Video

The setting controls the type of video adapter used for the primary monitor of

the system. Available options: EGA/VGA , CGA 40, CGA 80, MONO.

Halt On

The setting determines whether the system will stop if an error is detected at

boot. Available options are:

All Errors The system stops when any error is detected.

No Errors The system doesn’t stop for any detected error.

All, But Keyboard The system doesn’t stop for a keyboard error.

All, But Diskette The system doesn’t stop for a disk error.

All, But Disk/Key The system doesn’t stop for either a disk or a

keyboard error.

Base/Extended/Total Memory

The three items show the memory status of your system (read only).

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 60 61

Keine Kommentare

MSI MS-8801 Spezifikationen Seite 39