
Hardware Setup
2-19
JMDM1
Wake On Ring Connector: JMDM1
This connector allows you to connect to a modem card with Wake On
Ring function. The connector will power up the system when a signal is
received through the modem card.
NC
MDM_WAKEUP
NC
5VSB
1
GND
IrDA Infrared Module Connector: J14
This connector allows you to connect to an IrDA Infrared module. You
must configure the setting through the BIOS setup to use the IR function.
J14
1
6
5
10
Note: Modem wake-up signal is active “low”.
1 VCC 6 NC
2NC 7NC
3 IRRX 8 5VSB
4 GND 9 CIRRX
5 IRTX 10 NC
Pin Signal Pin Signal
Kommentare zu diesen Handbüchern