MSI MS-9105 Bedienerhandbuch PDF herunterladen (Seite 64)

Chapter 3

3-22

EPP or ECP+EPP mode. Settings: EPP1.7 and EPP1.9.

ECP Mode Use DMA

The item specifies the DMA channel 1 or 3 for the parallel port when it

is set to ECP or ECP+EPP mode.

Init Display First

This item specifies which VGA card is your primary graphics adapter.

Available settings: PCI Slot and AGP.

OnChip USB Controller

The item specifies which USB (Universal Serial Bus) Port is enabled.

Settings: All Disabled, ALL Enabled, 2&3 USB Port, 1&2 USB Port, 1&3

USB Port, 3 USB Port, 2 USB Port, 1 USB Port.

USB Keyboard Support

Set to Enabled if your need to use an USB keyboard in the operating system

that does not support or have any USB driver installed, such as DOS and

SCO Unix.

IDE HDD Block Mode

This allows your hard disk controller to use the fast block mode to transfer

data to and from the hard disk drive. Block mode is also called block

transfer, multiple commands or multiple sector read/write. Enabled enables

IDE controller to use block mode; Disabled allows the controller to use

standard mode.

PWRON After PWR-Fail

This item specifies whether your system will reboot after a power failure or

interrupt occurs. Available settins are:

Off Leaves the computer in the power off state.

On Reboots the computer.

Former-Sts Restores the system to the previous status before

power failure or interrupt occured.

Power Status Led

This item sets how the system uses Power LED on the case to indicate the

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 81 82

Keine Kommentare

MSI MS-9105 Bedienerhandbuch Seite 64